Huracan Normal fender by LB Works – Guide

By now we have all seen the LB Works Lamborghini Huracan finished in bright red featuring those typical Kato-san wide fenders crafted onto the Bull … but not everybody will want to have their V10 Lamborghini cut to be able to fit these ‘riveted’ fenders and that very low Airrex suspension setup.

That is why LB Performance also offers the ‘Normal fender’ version of their top of the line kit, which looks almost as impressive as the wide fender edition, but doesn’t require any cutting into that expensive Italian suit …

So you will still have the very low front spoiler lip in either FRP ($ 3,780) or CFRP ($4,860) together with the very stylish side sills, again available in FRP ($4,320) or CFRP ($5,400) and the impressive rear diffuser in FRP ($4,320) or CFRP ($5,400) … you will however have to decided which rear wing you would like to fit.

There are two versions, both in that well-known ‘Duck tail’ design … but Version 1 is the taller one as seen on the red, Wide fender version while Version 2 is the lower one seen on the wide Normal fender Huracán. Version 1 in FRP will be $5,400 or in CFRP for $6,480 while the slightly lower, smaller Version 2 comes to $3,780 in FRP and $4,860 in CRFP.

I don’t know if you would be able to fit the AirRex suspension system to the LB Works Narrow fender version too, but in case you can it would set you back an additional $9,500 in fact, and judging from the photos of the white LB Works Huracán it does look she is riding a lot lower than usual.

If you do a quick addition this LB Works Huracán Narrow fender version will come to $20,520 if you opt for the rear wing Version 2 and all parts in CFRP … that is $5,500 less than the Wide fender kit in CFRP … which mean those four additional fenders cost $1,375 each.